Download Print this page

Sharp ER-A457 Service Manual

Online communication function

Advertisement

Quick Links

ER-A457
ONLINE COMMUNICA TION FUNCTION
CHAPTER 1. OVERVIEW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
CHAPTER 2. SYSTEM CONFIGURATION . . . . . . . . . . . . . . . . . . . . . . 1
CHAPTER 3. SPECIFICATIONS OF RS-232 INTERFACE . . . . . . . . . 2
CHAPTER 4. SIGNAL CONNECTION DIAGRAM. . . . . . . . . . . . . . . . . 2
CHAPTER 5. RS-232 PROTOCOL . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
CHAPTER 6. CONTROL SIGNAL SEQUENCE . . . . . . . . . . . . . . . . . 11
CHAPTER 7. DATA BLOCK FORMAT . . . . . . . . . . . . . . . . . . . . . . . . 14
CHAPTER 8. ONLINE APPLICATION . . . . . . . . . . . . . . . . . . . . . . . . . 14
Parts marked with "
" is important for maintaining the safety of the set. Be sure to replace these parts with specified
ones for maintaining the safety and performance of the set.
SERVICE MANUAL
ELECTRONIC CASH
REGISTER
MODEL
MODEL
CONTENTS
SHARP CORPORATION
ER-A457
(For "V" version)
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.

Advertisement

loading

Summary of Contents for Sharp ER-A457

  • Page 1 SERVICE MANUAL ER-A457 ONLINE COMMUNICA TION FUNCTION ELECTRONIC CASH REGISTER MODEL ER-A457 MODEL (For "V" version) CONTENTS CHAPTER 1. OVERVIEW ........1 CHAPTER 2.
  • Page 2 This is a specification of the on-line data communication via RS-232 interface of the ER-A457 It enables the ER-A457 to perform on-line communication. For on-line data communication a ER-457 can be connected to a host computer. Also, their connection can be made via modems.
  • Page 3 CHAPTER 3. SPECIFICATIONS OF CHAPTER 4. SIGNAL CONNECTION RS-232 INTERFACE DIAGRAM 1. Online interface 1. Connection between the master (Host) and Satellite a) Interface : RS-232 b) Duplex type : Half-duplex / Full-duplex c) Line configuration : Direct connection/Modem connection 25PIN D-SUB 9PIN D-SUB d) Data rate...
  • Page 4 2. Connection between the terminal and MODEM 25PIN D-SUB 9PIN D-SUB MODEM TERMINAL FRAME GROUND is connected to the shield of the cable. SD : TRANSMITTED DATA RD : RECEIVED DATA DTR : DATA TERMINAL READY DSR : DATA SET READY RTS : REQUEST TO SEND DCD: DATA CARRIER DETECTOR CTS : CLEAR TO SEND...
  • Page 5 CHAPTER 7. DATA BLOCK FORMAT Example Memory image 1. Basic format 1) ID-ENQ : 10bytes Line image ENQ code (05h) Terminal No. 000001-999999 (6 bytes) Transmission sequence EOT is set as dummy cahracters. (3 bytes) 2) ACK : 1 byte 06h 3) NAK : 1 byte 15h CHAPTER 8.
  • Page 6 [JOB#6111] MRS = 00 Programming of the modem control 6111 6111-A: 1. Sensing of the CI signal Yes/No 1. Sensing of the CI signal 6111-A 6111-B: 1. Duplex type 1. Duplex type 6111-B Full duplex system Half duplex system [JOB#6112] MRS = 5 Programming of the transmission baud rate 6112 6112-A: Transmission baud rate...
  • Page 7 COPYRIGHT 2001 BY SHARP CORPORATION All rights reserved. Printed in Japan. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of the publisher.