Rear Brake - DAELIM S2-250 Service Manual

REAR WHEEL / BRAKE / SUSPENSION / SWING ARM
CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET
CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET
CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET
CALIPER BRACKET CALIPER BRACKET CALIPER BRACKET

REAR BRAKE

REMOVAL
● Remove the muffler.
● Loosen the rear break tube bolt and remove the break
tube.
● Loosen 2 bolts and remove rear break caliper.
INSPECTION
● Inspect break pad and disk.
● Measure the break disk thickness.
SERVICE LIMIT : 3mm
DISASSEMBLY
● Remove the rear break caliper.
● Inspect caliper assembly.
● Remove the pad spring, slide pin, caliper bracket, and
boot from the caliper body.
● Check the boot for wearand damage and replace if
necessany.
● Wind the caliper facing down with cloth to prevent the
piston or break fluid from leaking.
● Remove the piston from the caliper while blowing the
low-pressure air in the opening of the break hose.
·Never use the high-pressure air or bring the air gun
too close.
·Never touch the inside of the caliper
15-3