Repeater Mode - TP-Link TL-WR702N User Manual

Figure 2-2 Hardware Installation of the TL-WR702N in Router Mode
1. Connect the WAN port of TL-WR702N to the LAN Port on the DSL/Cable Modem.
2. Connect the WAN port on the DSL/Cable Modem to the wired Internet.
3. Plug the power plug of TL-WR702N in electrical wall socket.
4. Power on the DSL/Cable Modem, PC(s) and notebook(s).

2.3.3 Repeater Mode

TL-WR702N is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The SSID of TL-WR702N should be the same as that of the device you
repeat. To avoid the conflict of DHCP service with front-end devices, the DHCP server is default to
be closed on this mode. If you want to log in the management page, please set your computer's IP
address manually.
Figure 2-3 Hardware Installation of the TL-WR702N in Repeater Mode
1. Plug the power plug of TL-WR702N in electrical wall socket.
2. Power on the notebook(s).
TL-WR702N 150Mbps Wireless N Nano Router
- 7 -