TP-Link TL-WR702N User Manual page 167

1) Because the WEB Server port 80 will interfere with the WEB management port 80 on the
Router, you must change the WEB management port number to avoid interference.
2) To change the WEB management port number: Log in to the Router, click the "Security"
menu on the left of your browser, and click "Remote Management" submenu. On the
"Remote Management" page, type a port number except 80, such as 88, into the "Web
Management Port" field. Click Save and reboot the Router.
Note:
If the above configuration takes effect, configure to the Router by typing 192.168.0.188 (the
Router's LAN IP address: Web Management Port) in the address field of the Web browser.
3) Log in to the Router, click the "Forwarding" menu on the left of your browser, and click
the "Virtual Servers" submenu. On the "Virtual Servers" page, click Add New..., then
on the "Add or Modify a Virtual Server" page, enter "80" into the blank next to the
"Service Port", and your IP address next to the "IP Address", assuming 192.168.0.188
for an example, remember to Enable and Save.
TL-WR702N
Figure A-7 Remote Management
Figure A-8 Virtual Servers
- 161 -
150Mbps Wireless N Nano Router