TP-Link TL-WR702N User Manual page 71

TL-WR702N 150Mbps Wireless N Nano Router
Figure 5-15 Wireless Settings - Router
SSID - Enter a string of up to 32 characters. The same name of SSID (Service Set
Identification) must be assigned to all wireless devices in your network. The default SSID is
set to be TP-LINK_XXXXXX (XXXXXX indicates the last unique six numbers of each
Router's MAC address). But it is recommended strongly that you change your networks
name (SSID) to a different value. This value is case-sensitive. For example, TEST is NOT
the same as test.
Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the Router can be used. It may be illegal to use the wireless function of
the Router in a region other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for assistance.
Channel - This field determines which operating frequency will be used. The default channel
is set to Auto. It is not necessary to change the wireless channel unless you notice
interference problems with another nearby access point.
Mode - Select the desired mode. The default setting is 11bgn mixed.
• 11b only - Select if all of your wireless clients are 802.11b.
• 11g only - Select if all of your wireless clients are 802.11g.
• 11n only- Select only if all of your wireless clients are 802.11n.
• 11bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.
• 11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
- 65 -