TP-Link TL-WR702N User Manual page 30

150mbps wireless n nano router
Hide thumbs Also See for TL-WR702N:
Table of Contents

Advertisement

This page is for setting wireless security of your own AP. When computers and mobile phones
are connected to the AP, they should input the same password.
Disable Security - The wireless security function can be enabled or disabled. If disabled,
the wireless stations will be able to connect the Router without encryption. It is
recommended strongly to enable security.
PSK Password - ou can enter ASCII or Hexadecimal characters. The default password is
the last unique eight numbers of each Router's MAC address
For ASCII, the key can be made up of any numbers 0 to 9 and any letters A to Z, the length
should be between 8 and 63 characters.
For Hexadecimal, the key can be made up of any numbers 0 to 9 and letters A to F, the
length should be between 8 and 64 characters.
Please also note the key is case sensitive, this means that upper and lower case keys will
affect the outcome. It would also be a good idea to write down the key and all related wireless
security settings.
3.
Click the Next button in Figure 3-20. You will then see the Finish page. Click the Reboot
button to make your wireless configuration take effect and finish the Quick Setup.
3.2.5 Client Mode
When you choose Client on Working Mode page in Figure 3-5 , take the following steps:
1.
Click Next in Figure 3-5, and then Wireless Client page will appear as shown in Figure 3-21.
TL-WR702N
Figure 3-19 Quick Setup - Wireless Security Settings
Figure 3-20 Quick Setup - Finish
150Mbps Wireless N Nano Router
- 24 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents