Modifying Connection Speeds - Symantec PCANYWHERE 12.0 User Manual

106 Controlling another computer remotely
Ways to set up a remote computer

Modifying connection speeds

6
Under Connection, do one of the following:
Name or IP Address
Phone Number
7
If the pcAnywhere Gateway or Access Server is configured to require a
password for connections, type the password that is needed to connect.
8
If you want to connect to a specific group that is configured on the Access
Server, in the Group Name box, type the name of the group.
9
In the Details dialog box, click OK.
10
In the Remote Properties window, configure any additional settings that you
want to use for the connection.
See "Configuring a remote network connection"
See "Configuring a remote modem connection"
Symantec pcAnywhere automatically detects the connection speed when you
make a connection unless you change this setting.
High bandwidth is used for high-speed connections, such as LANs and cable
modems. Symantec pcAnywhere optimizes video resolution and speed for
high-bandwidth connections. Low bandwidth is used for low-speed connections,
such as analog modems. Symantec pcAnywhere uses a lower video resolution for
low-bandwidth connections to optimize speed.
Symantec pcAnywhere automatically applies performance settings based on the
connection type. If you want to use performance settings that apply to a different
connection type, you must first manually change the connection type.
See " Adjusting video performance settings"
See "Changing display settings during a remote control session"
For TCP/IP connections, in the Name or IP Address box,
type the computer name or IP address of the pcAnywhere
Gateway or Access Server through which you want to
connect.
For modem connections, in the Phone Number box, type
the modem phone number of the pcAnywhere Gateway
or Access Server through which you want to connect.
This option is only available if a modem is installed and
properly configured on your computer.
on page 107.
on page 96.
on page 99.
on page 119.