Symantec NORTON GHOST PERSONAL EDITION User Manual page 52

Appendix A: Norton Ghost command-line switches
dst=1,szeL
-CRC32
The -CRC32 switch allows making a list of the files on a disk or partition, or
in an image file with CRC values for each, and to verify that list against the
original or a clone. The purpose is to allow both quick listing of the
contents of an image file and verification that a disk created by Norton
Ghost contains the same files as the original. CRC checking works file by
file with FAT partitions. NTFS partitions are CRC-checked within an image
file by each MFT table. It is not possible at present to obtain a list of files
failing a CRC check with an NTFS file system. When a CRC file is created
for an NTFS partition, only a single CRC value is generated. You can also
create a CRC file from an image file, and verify against a disk.
The full syntax for this switch is:
CRC32
-
dcreate
{File}},{
{File}}
Note that no spaces are allowed in the command line.
crcfile={File}::ASCII CRC32 file - default=ghost.crc
vlist={File}::Verification list file - default=ghost.ls
vexcept={File}::Verification exception file - no default
The possible actions (with descriptions) are:
create
Create an ASCII CRC32 file from a disk.
verify
Verify a disk from a CRC32 file.
pcreate
Create an ASCII CRC32 file from a partition.
pverify
Verify a partition from an ASCII CRC32 file.
52
action= create
, { |
dverify src=
| }, {{Disk Spec}|{Part Spec}|
crcfile=
{File}|
verify pcreate pverify
| |
vlist= vexcept=
{File}|
|