Symantec NORTON GHOST PERSONAL EDITION User Manual page 22

Chapter 3: Using Norton Ghost
3
4
5
22
No other devices.
Other peripheral devices not needing additional setup (for
example, Jaz or Zip drive).
SCSI tape drive requiring DOS ASPI driver setup.
Third-party device requiring DOS driver setup.
Peer-to-peer connection using LPT printer port.
Peer-to-peer connection using NetBIOS and network interface
cards connection.
Set up the hardware and system for the method chosen.
Ensure all hard drives are installed correctly and the BIOS of
the system is configured and correctly displays the valid
parameters of the drives.
Set up additional drivers required for other devices:
SCSI tape drive requiring DOS driver setup
Install the SCSI ASPI DOS driver in the config.sys file as outlined
in SCSI Tape Drive documentation.
Third-party device requiring DOS driver setup
Install the DOS driver as outlined in device documentation.
Peer-to-peer connection: LPT
Using a parallel data transfer connection cable, connect up the
two machines. Decide which machine is the master and which is
the slave.
Peer-to-peer connection: NetBIOS
Install network interface card (NIC).
Connect cabling.
Set up NIC using manufacturer's installation program.
Run NIC test program to check NIC and cabling.
Install NetBIOS networking software.
Select which machine is the master and which is the slave.
Test Hardware and DOS driver setup.
Start Norton Ghost. Optionally, add command-line switches. For
information on the Norton Ghost command-line switches, see
"Command-line switches"
Select the transfer method and Norton Ghost operation from
menu.
on page 47.