Symantec NORTON GHOST PERSONAL EDITION User Manual page 51

Command-line switches
Rule 2: If the destination disk is smaller than the original source disk (but
still large enough to accommodate the data from the source disk), the free
space left over after the data space has been satisfied will be distributed
between the destination partitions in proportion to the data usage in the
source partitions.
Examples of switch usage
To copy local drive one to local drive two:
ghostpe.exe -clone,mode=copy,src=1,dst=2
To connect using NetBIOS to another machine running Norton Ghost
in slave mode, and save a disk image of local drive two to the remote
file c:\drive2.gho:
ghostpe.exe -clone,mode=dump,src=2,dst=c:\drive2.gho -nbm
The slave machine can be started with ghostpe.exe -nbs
To copy the second partition of the local drive one the first partition of
local drive:
ghostpe.exe -clone,mode=pcopy,src=1:2,dst=2:1
To load drive two from an image file and resize the destination
partitions into a 60:40 allocation
ghostpe.exe -clone,mode=load,src=g:\2prtdisk.gho,dst=2
,sze1=60P,sze2=40P
To clone a three partition disk and keep the first partition on the
destination drive the same size as on the source disk, but divide up
the remaining space between the other partitions, leaving no
unallocated space
ghostpe.exe -
clone,mode=copy,src=1,dst=2,sze1=F,sze2=V,sze3=V
To load drive one from an image file and resize the first partition to
450 MB, the second to 1599 MB and the third to 2047 MB.
ghostpe.exe -clone,mode=load,src=g:\3prtdisk.gho,dst=1
,sze1=450M,sze2=1599M,sze3=2047M
To load a disk from an image file and resize the last partition to its
capacity. The first partition utilizes the remaining space.
ghostpe.exe -clone,mode=load,src=g:\2prtdisk.gho,
51