Bezel; Removing The Bezel - IBM 84885BU Maintenance And Troubleshooting Manual

Bezel

This section provides information about removing and installing the front bezel.

Removing the bezel

When working with some devices, such as additional optical drives, you must first
remove the bezel to access the device.
Complete the following steps to remove the bezel:
1. Unlock the side-cover lock.
2. Remove the side cover (see "Removing the side cover" on page 28).
3. For hot-swap hard disk drive models, slide the lock bar to the left.
4. Locate the bezel-release lever; then, press the bezel-release lever toward the
5. Pull the top of the bezel away from the chassis; then, push the bezel down to
6. Remove the bezel from the server and store the bezel in a safe place.
For instructions for replacing the bezel, see "Replacing the bezel" on page 31.
30
xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
front of the server.
disengage the bottom tabs.
Openings
Release
tab
Bezel
Tab
Hooks