IBM 84885BU Maintenance And Troubleshooting Manual page 117

Error code/symptom
166-342-000 System Management: Failed
(RSA BIST indicate failed tests.)
180-XXX-000 (Diagnostics LED failure)
180-XXX-001 (Failed Front LED panel test)
180-XXX-002 (Failed Diagnostics LED
panel test)
180-XXX-003 (Failed system board LED
test)
180-XXX-005 (Failed SCSI Backplane LED
test)
201-XXX-0NN (Failed Memory test, see
"Installing a memory module" on page 34)
202-XXX-001 (Failed System Cache test)
202-XXX-002 (Failed System Cache test)
206-XXX-000 (Failed Diskette Drive test)
214-XXX-000 (Failed Diskette Drive test)
215-XXX-000 (Failed IDE CD-ROM test)
217-198-XXX
(Could not establish drive parameters)
217-XXX-000 (Failed Fixed Disk test)
Note: If RAID is configured, the fixed disk
number refers to the RAID logical array.
217-XXX-001 (Failed BIOS Fixed Disk test)
Note: If RAID is configured, the fixed disk
number refers to the RAID logical array.
FRU/action
1. Make sure that the latest firmware levels for Remote
Supervisor Adapter II and BIOS are installed.
2. Disconnect all server and option power cords from the server, wait
30 seconds, reconnect, and retry.
3. Remote Supervisor Adapter II.
v Run diagnostic LED test for the failing LED.
v Information LED panel
v System board
v System board
1. SCSI backplane
2. SCSI backplane cable
3. System board
1. DIMM Location slots 1-6 where NN = DIMM location.
Note: NN 1=DIMM 1 NN 2=DIMM 2 NN 3=DIMM 3 NN 4=DIMM 4
NN 5=DIMM 5 NN 6=DIMM 6
2. System board
1. Microprocessor 1
2. System board
1. Microprocessor 2
2. System board
1. Rerun the test with another diskette.
2. Diskette drive cables.
3. Diskette drive.
4. System board.
1. Rerun the test with another diskette.
2. Cable.
3. Diskette drive.
4. System board.
1. Rerun the test with a different CD.
2. CD-ROM drive cables.
3. CD-ROM drive.
4. System board.
1. Check the cable and termination.
2. SCSI backplane.
3. Hard disk drive.
.
1. Fixed Disk 1
2. System board
1. Fixed Disk 2
2. System board
Chapter 6. Symptom-to-FRU index
107