Starting The Configuration/Setup Utility Program - IBM 84885BU Maintenance And Troubleshooting Manual

Starting the Configuration/Setup Utility program

Complete the following steps to start the Configuration/Setup Utility program:
1. Turn on the server.
2. When the prompt Press F1 for Configuration/Setup appears, press F1. If you
3. Select settings to view or change.
10
xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
have set both a power-on password and an administrator password, you must
type the administrator password to access the full Configuration/Setup Utility
menu. If you do not type the administrator password, a limited
Configuration/Setup Utility menu is available.