Scsi Ids For Hot-Swap Hard Disk Drives - IBM 84885BU Maintenance And Troubleshooting Manual

5. Install the hard disk drive in the hot-swap bay:
6. If you are installing additional hot-swap hard disk drives, do so now; otherwise,
7. If you have other options to install or remove, do so now; otherwise go to

SCSI IDs for hot-swap hard disk drives

The hot-swap-drive backplane controls the SCSI IDs for the internal hot-swap drive
bays. The SCSI ID for each hot-swap hard disk drive is printed on the hot-swap
lock bar. The following table lists the SCSI IDs for the hard disk drives and
backplane that are connected to one channel in hot-swap hard disk drive models. In
the typical configuration, the standard hard disk drives and backplane are
connected to channel B.
42
xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
a. Make sure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status indicator to make sure that the hard disk
drive is operating properly. (You might have to restart the server before the
drive is recognized.) If the amber hard disk drive status LED for a drive is lit
continuously, it indicates that the drive is faulty and must be replaced. If the
green hard disk drive activity LED is flashing, it indicates that the drive is
being accessed.
Note: If the server is configured for RAID operation using an optional
ServeRAID adapter, you might have to reconfigure the disk arrays
after installing hard disk drives. See the ServeRAID documentation
on the IBM ServeRAID Support CD for additional information about
RAID operation and complete instructions for using ServeRAID
Manager.
replace the hot-swap lock bar.
"Completing the installation" on page 60.
Device
Drive bay 9
Drive bay 8
Drive bay 7
Drive bay 6
Drive bay 5
Drive bay 4
Adaptec AIC 7902 controller
Hot-swap backplane
SCSI ID
0
1
2
3
4
5
7
8