Replacing The Battery - IBM 84885BU Maintenance And Troubleshooting Manual

4. Complete the installation of the optional SATA adapter.

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
To order replacement batteries, call 1-800-426-7378 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure the server and reset the
c. Thread the large connector into the small back-panel opening on the rear of
a bay; then, orient the connector so that the blue signal cable is toward the
front or outside of the server (see the preceding illustration) and gently pull
the connector into place.
d. Secure the connector with the two screws you removed in step 3b on page
56.
e. Connect the power-cable drop to the connector. The connectors are keyed
and can be inserted only one way.
f. Repeat steps 3b on page 56 through 3e for the second SATA cable that
comes with the ServeRAID-7t S-ATA adapter.
g. Press in on the drive-cage release tab and rotate the drive cage partially
back into the server. Press the drive-cage release latch and rotate the drive
cage the rest of the way back into the server, allowing the release latch to
spring back into position.
h. Route the SATA cables through the upper slot in the front
adapter-support-bracket assembly; then, connect the other end of the SATA
cables to the ServeRAID-7t S-ATA adapter.
system date and time.
Chapter 4. Customer replacement units
57