Updating Remote Supervisor Adapter Ii Firmware - IBM 84885BU Maintenance And Troubleshooting Manual

10. Replace the frame-support bracket (see "Removing and installing the support
11. Replace the side cover (see "Replacing the side cover" on page 29).
12. Connect the server to a power source, keyboard, monitor, and mouse.
13. Turn on the server. The Configuration/Setup Utility program starts.
14. Follow the instructions to erase the existing password or create a new
15. Select Save Settings and press Enter.

Updating Remote Supervisor Adapter II firmware

Information about updating the firmware of the Remote Supervisor Adapter II can be
found in the Remote Supervisor Adapter II User's Guide.
20
xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
Default
(pins 1 and 2)
1 2 3
BIOS recovery
(no jumper)
BIOS
recovery
(JCON1)
7. Move the CMOS recovery jumper from pins 1 and 2 to pins 2 and 3.
8. Wait 60 seconds; then, return the CMOS recovery jumper to pins 1 and 2.
9. Replace any adapters that were removed.
bracket" on page 32).
You can now start the server one time, without having to use the power-on
password, and start the Configuration/Setup Utility program. You can either
delete the old password or set a new power-on password. If you do not
change or delete the password, the next time you start the server the original
power-on password will be reinstated.
password.
Default
(pins 1 and 2)
1 2 3
Clear CMOS data
(pins 2 and 3)
CMOS
data
(JCMOS1)