Extended Ibm Printer Emulation - Axis 27980R1 User Manual

Extended IBM Printer Emulation

AXIS 5570e User's Manual
1. Make sure that the writer is stopped by typing ENDWTR xxxxPRT01
on the AS/400 command line, where xxxxPRT01 is the printer device
name. Press ENTER.
2. Type VRYCFG CFGOBJ(xxxxPRT01) CFGTYPE(*DEV)
STATUS(*OFF) to vary off the printer device, where xxxxPRT01 is the
printer device name. Press ENTER.
3. Type CHGDEVPRT xxxxPRT01 to change the printer device name, where
xxxxPRT01 is the printer device name. Press F4.
4. Under DBCS Feature (IGCFEAT) amend the Device Features and Last Code
Point to the appropriate value corresponding to the country language.
Country Device features
Korea 2424K1
Japan 2424J1
China 2424S1
Device features and Last Code Point for Country options
5. Type VRYCFG CFGOBJ(xxxxPRT01) CFGTYPE(*DEV)
STATUS(*ON) on the AS/400 command line to vary on the printer device,
where xxxxPRT01 is the printer device name. Press ENTER.
6. Type STRPRTWTR xxxxPRT01 to start the Writer, where xxxxPRT01
is the printer device name. Press ENTER.
7. Direct a printout to this printer device to confirm that the above changes
have been implemented correctly.
Extended emulation will only work in SBCS mode. Before entering
extended emulation you will have to change to single byte mode by
sending shift in.
<SI> (SCS Shift In Control Code)
%CONFIG+
SAVE;
%CONFIG-
<SO>(SCS Shift Out Control Code)
Example (with DBCS mode before entering extended emulation)
DBCS Support
Last Code Point
D3FE
68FE
6FFE
199