Constant Power And Ignition Wires - Directed Electronics BOA 165B Owner's Installation Manual

step 2

Constant Power and Ignition wires

Almost all power and ignition wires can be found behind the key
cylinder under the lower drivers side dash panel. Using the
appropriate hand tools, remove the lower dash panel using care
not to break any parts. If the panel does not come off easily
check for any additional screws you may have missed.
Once the lower dash panel has been removed, locate the ignition
harness at the back of the key cylinder. This is usually a group of
thicker wires. With the ignition harness exposed, use your LED
tester to find your power and ignition wires.
Place the black lead of the LED tester to a clean metal surface in
the kick panel area and secure it. Probe one of the thicker gauge
wires. The color and identity of your specific vehicle wiring can
be obtained at www.boasecurity.com. With the key in the OFF
position, test the suspect wire. The constant power wire will illu-
minate the LED tester.
12
© 2004 Directed Electronics, Inc.