Directed Electronics BOA 165B Owner's Installation Manual page 20

Installing the hood pin switch requires drilling a ¼-inch hole in the
metal lip under the hood. Choose a location that will allow the pin
switch to be depressed when the hood is closed. The pin switch has
a spade connector on the bottom for the wire connection.
Place the wire with the spade connector onto the pin switch and
run the wire into the vehicle's passenger compartment through a
factory rubber grommet. Using a sharp, pointed object poke a
hole into the grommet and attach the wire to the object with
electrical tape. Pull the wire through the grommet taking extra
care to keep the wire away from any moving parts or anything
that will generate extreme heat. Once the wire is run into the
vehicle and secured from any moving parts, solder the wire to
the GRAY (H1/4) wire on the main wire connector and wrap
the connection with electrical tape.
important! Do not use the vehicle until you confirm the
operation of the hood pin shutdown.
The bypass toggle switch is designed to bypass the remote start
in an emergency or to disable the remote start functions
© 2004 Directed Electronics, Inc. 17