Directed Electronics BOA 165B Owner's Installation Manual page 22

Using the web information on the vehicle, locate the suspected
wire and place the red lead of the LED tester to a constant (+)12
volt source and secure it. Probe the suspected wire. With the
switch in the off position the LED tester should be extinguished.
While watching the LED tester, turn the switch to the parking
light position. The LED tester should illuminate green. While
testing the suspected wire, run the dash dimmer light control up
and down — the voltage should NOT vary (LED tester illumi-
nation). If the voltage does vary, continue probing to find the
correct wire.
Once you have identified the correct wire, strip a small portion
of insulation off this wire and solder the WHITE (H1/8) wire
from the main connector to it and wrap the connection with
electrical tape.
19
© 2004 Directed Electronics, Inc.