Extended Run Time; Disable/Enable Led Flashing; Constant Output - Directed Electronics ONE-WAY FM AUTOMATIC/MANUAL TRANSMISSION User Manual

To enter Cold Weather Mode:
x
Rapidly press twice. The remote's LED will start flashing.
x
Press and hold until the parking lights will flash for 2 seconds, pause, and then flash
three times.
To exit Cold Weather Mode, do any one of the following actions:
x
Open the hood.
x
Start the engine by remote.
x
Turn the ignition key to the IGNITION ON (RUN) position.
x
Rapidly press twice. The re mote's LED will start flashing.
Press and hold until the parking lights will flash for 2 seconds, pause, and then
flash twice.
If Safe Start is enabled, you can activate Cold Weather Mode by:
x
Pressing and releasing the button, then;
x
Pressing and holding the button until the parking lights flash 3 times.
To verify whether the system is in Cold Weather Mode (automatic transmissions only):
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal is
pressed.

Extended Run Time

With the vehicle running under a remote start, pressing and holding the
seconds will reset the run time counter to zero and restart the run time cycle from the beginning.
x
The horn (if programmed) will honk once;
x
The parking lights will flash slowly 3 times then remain lit.
To stop the vehicle at any moment, simply press the
out once per remote start.
Example: If your Module is programmed for a runtime of 3 minutes and your vehicle has been
running for 2 minutes already, pressing the
will run for another cycle (in this case, 3 minutes).

Disable/Enable LED flashing

To Disable the LED: Press and
times.
To Enable the LED: Press and

Constant output

x
Pressing and holding the button for more than 3 seconds will lock all doors and will
send a constant pulse as long as the
This constant pulse can be configured to activate certain functionalities such as rolling up
the windows – Please refer to your installer to see if your vehicle is compatible with
this option.
x
Pressing and holding the button for more than 3 seconds will unlock all doors and will
send a constant pulse as long as the
User guide
button for more than 3
button. This procedure can only be carried
button will reset the counter to zero and the Engine
simultaneously until the parking lights flash three
simultaneously until the parking lights flash once.
button is held down (maximum of 15 seconds).
button is held down (maximum of 15 seconds).
P.9