Manual Wireless Settings - D-Link DIR-632 User Manual

Section 3 - Configuration
Enable Wireless:
Check the box to enable the wireless function. If you do not want to use wireless,
uncheck the box to disable all the wireless functions. Click Add.New to create your
own time schedule to enable the wireless function.
Wireless Network
Service Set Identifier (SSID) is the name of your wireless network. Create a name
Name:
using up to 32 characters. The SSID is case-sensitive.
802.11 Mode:
Select one of the following:
802.11g.Only - Select if all of your wireless clients are 802.11g.
802.11n.Only - Select only if all of your wireless clients are 802.11n.
Mixed. 802.11n. and. 802.11g - Select if you are using a mix of 802.11n and
802.11g wireless clients.
Enable Auto Channel The Auto.Channel.Scan setting can be selected to allow the DIR-632 to choose the
Scan:
channel with the least amount of interference.
Wireless Channel:
Indicates the channel setting for the DIR-632. By default the channel is set to 6. The
Channel can be changed to fit the channel setting for an existing wireless network
or to customize the wireless network. If you enable Auto.Channel.Scan, this option
will be greyed out.
Transmission Rate: Select the transmit rate. It is strongly suggested to select Best. (Auto) for best
performance.
Channel Width:
Select the Channel Width:
Auto.20/40 - Select if you are using both 802.11n
and non-802.11n wireless devices.
20MHz - Select if you are not using any 802.11n wireless clients. This is the default
setting.
Visibility Status:
Select Invisible if you do not want the SSID of your wireless network to be broadcasted by the DIR-632. If Invisible is selected, the SSID of the DIR-632 will not
be seen by Site Survey utilities so your wireless clients will have to know the SSID of your DIR-632 in order to connect to it.
Wireless Security: Refer to page 76 for more information regarding wireless security.
D-Link DIR-632 User Manual

Manual Wireless Settings

24