Pppoe (Dsl) - D-Link DIR-632 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password.
This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer needed and
will not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down menu.
Connection:
Advanced DNS
This is a free security option that provides Anti-Phishing and auto correction of URL
typos. Check Enable.Advanced.DNS.Service if you wish to use this free security option.
Service:
Address Mode:
Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS
server addresses. In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in the next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnection
Select either Always-on, On-Demand, or Manual.
Mode:
Enter a maximum idle time during which the Internet connection is maintained during
Maximum Idle Time:
inactivity. To disable this feature, enable Auto-reconnect.
DNS Addresses:
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE only).
Maximum Transmission Unit - you may need to change the MTU for optimal
MTU:
performance with your specific ISP. 1492 is the default MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on
the Broadband Router. It is not recommended that you change the default MAC address
unless required by your ISP. You can use the Clone.Your.PC's.MAC.Address button to
replace the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-632 User Manual
Internet Setup

PPPoE (DSL)

19