Administrator Settings; Change Password; Remote Management - D-Link DIR-632 User Manual

Section 3 - Configuration
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management. There are two accounts that
can access the management interface through the web browser. The accounts are admin and user. Admin has read/write access while user has
read-only access. User can only view the settings but cannot make any changes. Only the admin account has the ability to change both admin and
user account passwords.
Admin Password: Enter a new password for the Administrator Login Name. The administrator can
make changes to the settings.
User Password:
Enter the new password for the User login. If you login as the User, you can only
see the settings, but cannot change them.
Gateway Name:
Enter a name for the DIR-632 router.
Enable Graphical
Enables a challenge-response test to require users to type letters or numbers
Authentication:
from a distorted image displayed on the screen to prevent online hackers and
unauthorized users from gaining access to your router's network settings.
Remote
Remote management allows the DIR-632 to be configured from the Internet by a web
Management:
browser. A username and password is still required to access the Web-Management
interface. In general, only a member of your network can browse the built-in
web pages to perform Administrator tasks. This feature enables you to perform
Administrator tasks from the remote (Internet) host.
Remote Admin The port number used to access the DIR-632.
Example: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address of the DIR-632
Port:
and 8080 is the port used for the Web Management interface.
This section will list any rules that are created. You may click the Edit icon to
Inbound Filter:
change the settings or enable/disable the rule, or click the Delete icon to remove
the rule.
D-Link DIR-632 User Manual

Administrator Settings

59