Manually Enabling Ficon - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 24 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Manually Enabling FICON

This section describes the procedure to manually enabled FICON on a VSAN. If you have already
Tip
enabled FICON on the required VSAN using the automated setup (recommended), skip to the
Configuration Automatic Save" section on page
To manually enable FICON on a VSAN, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# vsan database
switch(config-vsan-db)# vsan 5
switch(config-vsan-db)# do show vsan usage
4 vsan configured
configured vsans:1-2,5,26
vsans available for configuration:3-4,6-25,27-4093
switch(config-vsan-db)# exit
Step 3
switch(config)# in-order-guarantee vsan 5
Step 4
switch(config)# fcdomain domain 2 static vsan 2
Step 5
switch(config)# fabric-binding activate vsan 2 force
Step 6
switch(config)# zone default-zone permit vsan 2
Step 7
switch(config)# ficon vsan 2
switch(config-ficon)#
switch(config)# no ficon vsan 6
Step 8
switch(config-ficon)# no host port control
OL-6973-03, Cisco MDS SAN-OS Release 2.x
24-19.
Purpose
Enters configuration mode.
Enables VSAN 5.
Activates in-order delivery for VSAN 5.
See Chapter 21, "Configuring Fibre
Channel Routing Services and
Protocols."
Configures the domain ID for VSAN 2.
See Chapter 14, "Configuring Domain
Parameters."
Activates fabric binding on VSAN 2.
See the "Fabric Binding Configuration"
section in this chapter.
Sets the default zone to permit for VSAN
2.
See the "CUP In-Band Management"
section in this chapter.
Enables FICON on VSAN 2.
Disables the FICON feature on VSAN 6.
Prohibits mainframe users from moving
the switch to an offline state.
See the "Host Moves the Switch Offline"
section in this chapter.
Cisco MDS 9000 Family Configuration Guide
Manually Enabling FICON
"Running
24-15