Table of Contents
Advertisement
Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
For example, if an iSCSI target was created for a Fibre Channel target port with pWWN
31:00:11:22:33:44:55:66 and that pWWN contains LUN 0, LUN 1, and LUN 2, those LUNs would
become available to an IP host via the iSCSI target node name
iqn.1987-05.com.cisco:05.<MDS_switch_management_IP_address>.01-01.3100112233445566 (see
Figure
Figure 35-5 Dynamic Target Mapping
IP host A
iSCSI
iSCSI
iqn.host A
Each iSCSI initiator may not have access to all targets depending on the configured access control
Note
mechanisms (see
To enable dynamic importing of Fibre Channel targets into iSCSI, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# iscsi import target fc
Cisco MDS 9000 Family Configuration Guide
35-6
35-5).
IP Network
iqn.1987-05.com.cisco:05.<mgnt-IPaddr>.01-01.3100112233445566
"iSCSI Access Control" section on page
MDS-mgntIP
Virtual iSCSI Target
iSCSI
LUN0
1/1
LUN1
LUN2
35-19).
Purpose
Enters configuration mode.
IPS modules and MPS-14/2 modules dynamically
import all Fibre Channel targets in the Fibre Channel
SAN into the IP network.
Chapter 35
Configuring iSCSI
pwwn 31.00.11.22.33.44.55.66
LUN0
LUN1
LUN2
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
