Table of Contents
Advertisement
Persistent FC IDs Manual Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To configure a different area ID for the HBA port, follow these steps:
Step 1
Obtain the Port WWN (Port Name field) ID of the HBA using the show flogi database command).
switch# show flogi database
------------------------------------------------------------------------------------------
INTERFACE
------------------------------------------------------------------------------------------
fc1/9
fc1/10
Note
Step 2
Shut down the HBA interface in the MDS switch.
switch# conf t
switch(config)# interface fc1/9
switch(config-if)# shutdown
switch(config-if)# end
switch#
Verify that the FC ID feature is enabled using the show fcdomain vsan command.
Step 3
switch# show fcdomain vsan 1
...
Local switch configuration information:
If this feature is disabled, continue with this procedure to enable the FC ID persistence.
If this feature is already enabled, skip to
Step 4
Enable the FC ID persistence feature in the Cisco MDS switch.
switch# conf t
switch(config)# fcdomain fcid persistent vsan 1
switch(config)# end
switch#
Assign a new FC ID with a different area allocation. In this example, we replace 77 with ee.
Step 5
switch# conf t
switch(config)# fcdomain fcid database
switch(config-fcid-db)# vsan 3 wwn 50:05:08:b2:00:71:c8:c2 fcid 0x6fee00 area
Step 6
Enable the HBA interface in the Cisco MDS switch.
switch# conf t
switch(config)# interface fc1/9
switch(config-if)# no shutdown
switch(config-if)# end
switch#
Cisco MDS 9000 Family Configuration Guide
14-12
VSAN
FCID
3
0x6f7703
3
0x6f7704
Both FC IDs in this setup have the same area 77 assignment.
State: Enabled
FCID persistence: Disabled
PORT NAME
50:05:08:b2:00:71:c8:c2
50:06:0e:80:03:29:61:0f
Step
5.
Chapter 14
Configuring Domain Parameters
NODE NAME
50:05:08:b2:00:71:c8:c0
50:06:0e:80:03:29:61:0f
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
