Recovery From The Switch(Boot)# Prompt - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 6 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Boot the kickstart image file from the required server.
Step 4
loader> boot tftp://172.16.10.100/kickstart-image1
Address: 172.16.1.2
Netmask: 255.255.255.0
Server: 172.16.10.100
Gateway: 172.16.1.1
Booting: /kick-282 console=ttyS0,9600n8nn quiet loader_ver= "2.1(2)"....
............................................Image verification OK
Starting kernel...
INIT: version 2.78 booting
Checking all filesystems..... done.
Loading system software
INIT: Sending processes the TERM signal
Sending all processes the TERM signal... done.
Sending all processes the KILL signal... done.
Entering single-user mode...
INIT: Going single user
INIT: Sending processes the TERM signal
switch(boot)#
The
Issue the init system command at the
Step 5
switch(boot)# init system
Step 6 Follow the procedure specified in the

Recovery from the switch(boot)# Prompt

To recover a system image using the kickstart image for a switch with a single supervisor module, follow
these steps:
Change to configuration mode and configure the IP address of the mgmt0 interface.
Step 1
Follow this step if you issued an init system command. Otherwise, skip to
Step 2
a.
b.
Issue the no shutdown command to enable the mgmt0 interface on the switch.
Step 3
switch(boot)(config-mgmt0)# no shutdown
OL-6973-03, Cisco MDS SAN-OS Release 2.x
prompt indicates that you have a usable Kickstart image.
switch(boot)#
switch(boot)# config t
switch(boot)(config)# interface mgmt0
Issue the ip address command to configure the local IP address and the subnet mask for the switch.
switch(boot)(config-mgmt0)# ip address 172.16.1.2 255.255.255.0
Issue the ip default-gateway command to configure the IP address of the default gateway.
switch(boot)(config-mgmt0)# ip default-gateway 172.16.1.1
prompt.
switch(boot)#
"Recovery from the switch(boot)# Prompt" section on page
Cisco MDS 9000 Family Configuration Guide
Corrupted Bootflash Recovery
6-35.
Step 3.
6-35