Portchannel Configuration Verification - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 13 Configuring PortChannels
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

PortChannel Configuration Verification

You can view specific information about existing PortChannels at any time from EXEC mode. The
following show commands provide further details on existing PortChannels. You can force all screen
output to go to a printer or save it to a file. See Examples
The show port-channel summary command displays a summary of PortChannels within the switch. A
one-line summary of each PortChannel provides the administrative state, the operational state, the
number of attached and active interfaces (up), and the first operational port (FOP), which is the primary
operational interface selected in the PortChannel to carry control-plane traffic (no load-balancing). The
FOP is the first port that comes up in a PortChannel and can change if the port goes down.The FOP is
also identified by an asterisk ( * ).
Example 13-1 Displays the PortChannel Summary
switch# show port-channel summary
------------------------------------------------------------------------------
Interface
------------------------------------------------------------------------------
port-channel 77
port-channel 78
port-channel 79
Example 13-2 Displays the PortChannel Configured in the Default ON Mode
switch# show port-channel database
port-channel 77
port-channel 78
port-channel 79
Example 13-3 Displays the PortChannel Configured in the ACTIVE Mode
switch# show port-channel database
port-channel 77
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Total Ports
Administrative channel mode is on
Operational channel mode is on
Last membership update succeeded
2 ports in total, 0 ports up
Ports: fcip1 [down]
fcip2 [down]
Administrative channel mode is on
Operational channel mode is on
Last membership update succeeded
2 ports in total, 0 ports up
Ports: fc2/1 [down]
fc2/5 [down]
Administrative channel mode is on
Operational channel mode is on
Last membership update succeeded
First operational port is fcip200
2 ports in total, 2 ports up
Ports: fcip101 [up]
fcip200 [up] *
Administrative channel mode is active
Operational channel mode is active
Last membership update succeeded
2 ports in total, 0 ports up
Ports: fcip1 [down]
13-1
Oper Ports
2 0
2 0
2 2
Cisco MDS 9000 Family Configuration Guide
PortChannel Configuration Verification
to 13-6.
First Oper Port
--
--
fcip200
13-17