Table of Contents
Advertisement
Chapter 10
Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Identifying Module LEDs
Table 10-5
Table 10-5
LED
Status Green
Speed On
Link
OL-6973-03, Cisco MDS SAN-OS Release 2.x
describes the LEDs for the Cisco MDS 9200 Series integrated supervisor modules.
LEDs for the Cisco MDS 9200 Series Supervisor Modules
Status
Description
All diagnostics pass. The module is operational (normal initialization sequence).
Orange
The module is booting or running diagnostics (normal initialization sequence).
or
The inlet air temperature of the system has exceeded the maximum system
operating temperature limit (a minor environmental warning). To ensure
maximum product life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red
The diagnostic test failed. The module is not operational because a fault occurred
during the initialization sequence.
or
he inlet air temperature of the system has exceeded the safe operating
T
temperature limits of the card (a major environmental warning). The card has
been shut down to prevent permanent damage. The system will be shut down after
two minutes if this condition is not cleared.
2-Gbps mode and beacon mode disabled.
Off
1-Gbps mode and beacon mode disabled.
Flashing
Beacon mode enabled. See the
page
11-18.
Solid green Link is up.
Solid
Link is disabled by software.
yellow
Flashing
A fault condition exists.
yellow
Off
No link.
"Identifying the Beacon LEDs" section on
Cisco MDS 9000 Family Configuration Guide
Identifying Module LEDs
10-11
Advertisement
Table of Contents
