Table of Contents
Advertisement
Chapter 11
Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 3
switch(config-if)# ip address 172.16.1.2
255 255.255.0
Step 4
switch(config-if)# no shutdown
Step 5
switch(config-if)# exit
switch(config)#
Step 6
switch(config)# ip default-gateway 1.1.1.4
switch(config)#
Step 7
switch(config)# exit
switch#
Step 8
switch# copy running-config startup-config
By default, the management port (mgmt0) operates at a speed of 100 Mbps and in full duplex mode.
Configuring the speed to auto will internally map to100 Mbps, and configuring the duplex mode to auto
will internally map to full duplex. If the duplex mode is configured as auto or full, then the peer device
should not be configured as full duplex.
Note
You need to explicitly configure a default gateway to connect to the switch and send IP packets or add a
route for each subnet.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Configuring Management Interfaces
Purpose
Enters the IP address and IP subnet mask for the
interface specified in Step 2.
Enables the interface.
Returns to configuration mode.
Configures the default gateway IP address.
Returns to EXEC mode.
(Optional) Saves your configuration changes to the
file system.
If you wish to save your configuration, you
Note
can issue this command at any time.
Cisco MDS 9000 Family Configuration Guide
11-21
Advertisement
Table of Contents
