Water System - Dimension One Spas Sarena Bay Owner's Manual

Electrical System (Cont)
Symptom
3 flashing LEDs
appear on the
Top Side Control
Spa lights always
start in the
default light
sequence

Water System

Symptom Problem
Pulsating jets Water level too low
1.
No Jet Action,
or action is
2.
poor
3.
4.
5.
The "Check Possible sensor errors
Water
Level....."
scrolling
message and /or
3 flashing
L.E.D.s appear
on the display.
Fountain The bottom of the
doesn't drain fountain has water that
will not drain out.
48
2003 Sarena Bay™
Export Owner's Manual
Problem Corrective Action
Possible sensor errors 1.
2.
If problem persists:
1.
2.
If problem persists:
Whenever the lights are Because both lights are synchronized together, they always return to a "common
turned off they always starting point" after they have been turned off for more than five seconds. This
turn on in Color Fade ensures that they will remain synchronized.
Fast mode
Corrective Action
Fill with water to the bottom of the OptiMount™ located next to the Skimmer
/Filter Basket.
Jets are turned off 1.
Diverter Valve 2.
turned
Dirty Filter 3.
Air lock 4.
Gate valve closed 5.
1.
2.
3.
4.
The water level in the spa is too high. Remove enough water to return the water
level to slightly below the bottom of the OptiMount™ located adjacent to the
Skimmer/Filter Basket.
Check water level
Clean filter
Turn off power
Restart the system
Call for service
Turn jets on by turning jet face clockwise
Turn the Diverter Valve clockwise or counter clockwise
Clean Filter
Loosen pump union to allow air to bleed
Open gate valve
Check water level
Clean filter
If problem continues:
a. Turn off power
b. Restart the spa
If problem persists:
a. Call your dealer for service