Change Water; Change Vision Cartridge; Spa Check Up; Overheat - Dimension One Spas Sarena Bay Owner's Manual

Export version
Hide thumbs Also See for Sarena Bay:
Table of Contents

Advertisement

Change Water

Change Vision Cartridge

Spa Check Up

The system can dismiss and reset the maintenance messages by pushing and holding the
Dimension One Spas ICON (logo)®, on the right end of the control, for 3 seconds. If you
press the Dimension One Spas ICON (logo)® for 5 seconds when there is no maintenance
message, it will put the spa in the "Standby" mode.
Note

Overheat

26
2003 Sarena Bay™
Export Owner's Manual
Every four months the top line of your Digital Display Window will read
"CHANGE WATER" and the message "TURN POWER OFF, DRAIN &
REFILL SPA...PUSH AND HOLD ICON BUTTON MORE THAN 3
SECONDS TO RESET THIS MESSAGE" will scroll from right to left on the
bottom line of the display.
To reset this message, push and hold the Dimension One Spas
ICON (logo)® Button located at the right hand side of the
control for 3 seconds.
When "CHANGE VISION CARTRIDGE" is displayed on the Digital Display
Window, the system is telling you that it is time to replace it.
To reset this message, push and hold the Dimension One Spas
ICON (logo)® Button located at the right hand side of the
control for 3 seconds.
If you purchased a Vision cartridge subsequent to the initial start up
of your hot tub, please follow the programming instructions for
VISION as outlined in the next
six-month time frame.
Note
When "SPA CHECK UP" is displayed on the Digital Display Window, we
recommend that you have your hot tub inspected by your dealer as a
preventative maintenance measure.
To reset this message, push and hold the Dimension One Spas
ICON (logo)® Button located at the right hand side of the
control for 3 seconds.
DO NOT ENTER THE WATER when "OVERHEAT" is displayed on
the control system Digital Display Window because the hot tub is in a high
temperature condition. If such a condition exists, check the water
temperature with a certified thermometer and if it is above 40° C (≅104° F),
remove the hot tub cover and allow the water to cool. If the problem recurs,
turn off all power to the hot tub and contact your local Authorized
Dimension One Spas Dealer, or authorized service center
The overheat condition could be caused by excessive filtration.
See the
Note
Vision Cartridge
Troubleshooting Guide
section to set the
.
section for more information.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2003 sarena bay

Table of Contents