Electrical System; Water System - Dimension One Spas Spa Owner's Manual

Electrical System

Symptom Problem
Will not turn on – No power
in any mode
Turns on by itself Normal automatic
daily filtration, or anti-
freeze cycle
Light is out
Burned out bulb
Pump shuts 1.
down
unexpectedly
while in use
2.
3 flashing lights Possible sensor errors
on the Topside
Control

Water System

Symptom Problem
Pulsing jets
Water level too low
No Jet Action, 1.
or action is
2.
poor
3.
4.
5.
Possible sensor errors
"Check Water
Level"
message or 3
flashing lights
on control
panel
Dimension One Spas – Reflections Owner's Manual
Corrective Action
Check circuit breaker and/or GFCI
No action required
Replace bulb
Automatic timer 1. Push JETS Button again to start another cycle. If desired, reprogram
has shut pump automatic pump timer for longer duration.
off
Motor over- 2. If pump(s) will not restart when JETS Button is pushed, call for service
heated and
automatic Make sure that the equipment panel vent area is not blocked. Vent
protective blockage can cause serious damage to your equipment.
device has shut
down pump(s)
1. Check water level, adjust if needed
2. Clean filter
If problem persists:
If problem still persists: Call your dealer for Service
Corrective Action
Fill spa to proper water level
Jets turned off 1. Turn jets on by turning jet face clockwise
Selector Valve 2. Turn the Selector Valve to the appropriate position
turned
Dirty Filter 3. Clean Filter
Air lock 4. Loosen pump union to allow air to bleed
Gate valve 5. Open gate valve
closed
1. Check water level
2. Clean filter
3. If problem continues:
Turn power off at GFCI breaker, then back on
If problem still persists, call your dealer for service
1. Turn power off at GFCI breaker, then back on
34