Flashing Display And/Or "Check Water Level; Erroneous Temperature On The Display; Ice; Cooling - Dimension One Spas Sarena Bay Owner's Manual

Flashing Display and/or
"Check Water Level"
Erroneous Temperature on
the Display

Ice

Cooling

The Dimension One Spas Scrolling Message Center Control has a battery back-up that will retain
the time of day for 30 days – even without an active power source. Additionally, it will also keep
your custom programming commands for up to 40 years without power. This battery back-up will
Feature
not provide power to heat or operate the hot tub.
2003 Sarena Bay™
Export Owner's Manual
DO NOT ENTER THE WATER if you see "3 flashing LEDs" on the
Top Side Control and/or the message, "CHECK WATER LEVEL -CLEAN
FILTER-IF PROBLEM CONTINUES, TURN OFF POWER AND
RESTART THE SYSTEM-IF PROBLEM CONTINUES, CALL FOR
SERVICE" in the Digital Display Window. Follow the instructions as stated.
Check the water temperature and if it is above 40° C (≅104° F) and DO
NOT ENTER THE WATER.
DO NOT ENTER THE WATER if you see a temperature reading of 0°C
(≅32° F) or 57.8° C (≅136° F) without first checking the actual water
temperature with a separate thermometer. The system has detected a
Temperature Probe Failure and the water may be too hot, or too cold, to
safely use.
Contact your local Authorized Dimension One Spas Dealer, or authorized
service center.
When "ICE CONDITION" and the water temperature are displayed on the
Digital Display Window, the air temperature in the equipment can has gone
below a factory-preset level, and the system has activated "Smart Winter
Mode." It will then automatically activate the pump(s) to circulate water.
This is a normal hot tub function. No corrective action is
necessary. This feature protects the spa from freezing.
Feature
When "COOLING" and the water temperature are displayed on the Digital
Display Window, the water temperature has reached 1° C (≅2° F) above the
set temperature. The circulation pump and ozone generator will turn off to
allow the water to cool back to the set temperature. This is a normal hot tub
function. No corrective action is necessary.
The circulation pump and ozone generator will be on while
either jet pump is on. They will remain on for 30 minutes after
the pump(s) turn off regardless of the water temperature.
Note
27