Table of Contents
Advertisement
Troubleshooting Guide
Heating System
Symptom
Does not heat
Too hot
Flashing temperature of 34°F or 134°F
appears on the display
Electrical System
Symptom
Will not turn on – in any mode
Turns on by itself
Light is out
Pump shuts down unexpectedly while in
use
3 flashing LEDs appear on the Top Side
Control
Water System
Symptom
Pulsating jets
No Jet Action, or action is poor
The water is cloudy or has a smell
Aquatic Fitness System
2003 Owner's Manual
Problem
1.
Temperature setting is too low
2.
Dirty filter
3.
Flow switch out of adjustment
1.
Temperature setting is to high
2.
High limit tripped
Possible temperature sensor failure
Problem
No power
Normal automatic daily power filtration, or
anti-freeze cycle
Burned out bulb
1.
Automatic 30-minute timer has shut
pump off
2.
Motor over-heated and automatic
protective device has shut down
pump(s)
Possible sensor errors
Problem
Water level too low
1.
HydroTherapy Jets closed
2.
Diverter Valve turned
3.
Dirty Filter
4.
Air lock
5.
Gate valve closed
The water has a chemical imbalance.
Corrective Action
1.
Turn up the thermostat
2.
Clean filter
3.
Call for service
1.
Turn down the thermostat
2.
Call for service
Call for service
Corrective Action
Check circuit breaker and/or GFCI
No action required
Replace bulb
1.
Push JETS pad again to start another
30-minute cycle
2.
If pump(s) will not restart when JETS
pad is pushed, call for service
Make sure that the equipment panel
vent area is not blocked. Vent
blockage can cause serious damage to
your equipment.
1.
Check water level
2.
Clean filter
If problem persists:
1.
Turn off power
2.
Restart the system
If problem persists:
Call for service
Corrective Action
Fill with water to 1" to 2" (2 to 5
centimeters) above the bottom of the tile
line
1.
Open Jets
2.
Turn the Diverter Valve clockwise or
counter clockwise
3.
Clean Filter
4.
Loosen pump union to allow air to
escape
5.
Open gate valve
1.
Check TA/pH
2.
Test and adjust
3.
Change Water if necessary
35
Advertisement
Table of Contents
