Kenmore 385.19110 Owner's Manual page 61

[5] Depress the foot control to sew a buttonhole.
The machine will sew a buttonhole in the following
order:
(1) Step 1 and 2: Front bartack and teft row
_2_ Starting point
(2) Step 3: Right row
(3) Step 4: Back bartack and locking stitches at the
end
_3b End point
(4) LED shows each sewing step and a dot witl blink
when the buttonhole is finished.
Dot
_ii_S_i_i_ii_ii_!i_!_!_!_i_i_:_!_!i!_i!_i_i_i_!_!i_ii!J!i_!_l_ .... i!_i!_i!i!i_!_ii_iiiiiiiiili_iiiii_i!i_!!i!!ii!ii_!i_i!iiiiii_ii_iil _
If you try to set_ : h, e r #a_i without raising the
foot, the LEDdisp!_ :#B_ _:UP _'to atert you to raise
the foot. ........
You can sew another layer of the buttonhole over the
previous stitching (see page 52).
(1)
(2)
/ur'}
[6] Remove the fabric and place a pin just before the
bartack at each end to prevent cutting bartacks.
Cut the opening with the seam ripper. Use an awt
to open the keyhole buttonhole.
_5} Pin
_6b Seam ripper
_ Awl
[_1 After the buttonhole sewing is finished, push the
buttonhole lever upward as far as it wilt go.
_8_ Buttonhole lever