Changing The Presser F; Changing Needles - Kenmore 385.19110 Owner's Manual

Changing t he
Presser Foot
WARNING:
Turn OFF the power switch before changing the foot
Always use the proper foot for the selected pattern.
Wrong foot can cause needle to break.
• To release:
Raise the needle and presser foot.
_) Foot holder .....
, To attach:
Align the hole in the foot holder with the threaded
hole on the presser bar and insert the setscrew
through the hole. Tighten the setscrew by turning it
clockwise.
Changing Needles
WARNING:
Turn OFF the power switch before changing the
needie.
[i] Loosen the needle clamp screw and pull out the
needle.
[2] Insert a new needle into the needle clamp with the
fiat side facing back.
Push the needle up against the stopper pin and
tighten the needle clamp screw firmly.
@ Needle clamp screw
_ Stopper pin
_ Flat side
@ Power switch
[3] To check the needle:
Place the flat side of the needle onto something fiat
(needle plate, glass etc).
The clearance between the needle and the fiat
surface should be consistent.
_) Clearance
WARNING:
Never use a bent or blunt needle, which can cause
to break.
®
16