Listing The Files On A Flash Device - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 30 Using the Flash File System
System configuration file set to: nvram
The nvram file will be used for configuration during the next bootup.
Console> (enable) show config mode
System configuration mode set to text.
System configuration file set to nvram.
Console> (enable) show running-config all
...........
begin
!
# ***** ALL (DEFAULT and NON-DEFAULT) CONFIGURATION *****
!
!
#time: Wed Jul 18 2001, 06:51:56
!
#version 6.3(0.74)
!
set password $2$FMFQ$HfZR5DUszVHIRhrz4h6V70
set enablepass $2$FMFQ$HfZR5DUszVHIRhrz4h6V70
set prompt Console>
set length 24 default
set logout 20
set config mode text nvram
set banner motd ^C^C
set banner lcd ^C^C
!
#test
set test diaglevel complete
!
#errordetection
set errordetection inband disable
set errordetection memory disable
set errordetection portcounter enable
!
#system
set system baud
set system modem disable
set system name
set system location
----display truncated------
Console> (enable)

Listing the Files on a Flash Device

To list the files on a Flash device, perform one of these tasks:
Task
Display a list of files on a Flash device.
Display a list of only deleted files on a Flash
device.
Display a list of all files on a Flash device,
including deleted files.
Display a detailed list of files on a Flash device.
78-12647-02
9600
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Command
dir [[m/]device:][filename]
dir [[m/]device:][filename] deleted
dir [[m/]device:][filename] all
dir [[m/]device:][filename] long
Using the Flash File System
30-3