Clearing The System Name; Setting The System Contact And Location - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 26 Administering the Switch
This example shows how to set the system prompt the switch:
Console> (enable) set prompt Catalyst4012>
Catalyst4012> (enable)

Clearing the System Name

To clear the system name, perform this task in privileged mode:
Task
Clear the system name.
This example shows how to clear the system name:
Console> (enable) set system name
System name cleared.
Console> (enable)

Setting the System Contact and Location

You can specify the contact name and location to help you with resource management tasks.
To specify the system contact and location, perform this task in privileged mode:
Task
Step 1
Set the system contact.
Step 2
Set the system location.
Step 3
Verify the global system information.
This example shows how to specify the system contact to sysadmin@corp.com and location to
Sunnyvale CA, and verify the configuration:
Console> (enable) set system contact sysadmin@corp.com
System contact set.
Console> (enable) set system location Sunnyvale CA
System location set.
Console> (enable) show system
PS1-Status PS2-Status
---------- ----------
ok
Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout
---------- ---------- ---------- -------------- ---------
ok
PS1-Type
------------ ------------
WS-C4008
Modem
------- ----- ------- ---- -------------------------
disable
Power Capacity of the Chassis: 1 supply
78-12647-02
ok
off ok
PS2-Type
WS-C4008
Baud Traffic Peak Peak-Time
9600 0% 0% Mon Jun 11 2001, 07:26:48
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Command
set system name
Command
set system contact [contact_string]
set system location [location_string]
show system
3,00:33:07 20 min
Setting the System Contact and Location
26-3