Removing An Etherchannel Bundle - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Configuring EtherChannel
This example shows how to set the EtherChannel VLAN cost for channel ID 768:
Console> (enable) show channel group 20
Admin Port
group
----- ----- ---------- --------- --------
20
20
Admin Port
group
----- ----- ------------------------------- ------------------------- ----------
20
20
Console> (enable)
Console> (enable) set channel vlancost 768 12
Channel 768 vlancost set to 12.
Console> (enable)

Removing an EtherChannel Bundle

To return a Fast EtherChannel or Gigabit EtherChannel bundle to its default configuration, perform this
task in privileged mode:
Task
Step 1
Return a channel to its default configuration (you
must perform this task on both sides of the
channel).
Step 2
Verify the configuration.
This example shows how to return a channel to its default configuration and how to verify the
configuration:
Console> (enable) set port channel 3/5-6 mode auto
Port(s) 3/5-6 channel mode set to auto.
Console> (enable) show port channel
No ports channelling
Console> (enable)
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
6-8
Status Channel
Mode
1/1 notconnect on
1/2 connected on
Device-ID
1/1
1/2 066510644(cat26-lnf(NET25))
Chapter 6 Configuring Fast EtherChannel and Gigabit EtherChannel
Channel
id
768
768
Port-ID
2/1
Command
set port channel port_list mode auto
show port channel [mod_num[/port_num]]
Platform
WS-C6009
78-12647-02