Resetting The 802.1X Configuration Parameters To The Default Values; Setting The Trace Severity - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 27 Configuring Switch Access Using AAA

Resetting the 802.1x Configuration Parameters to the Default Values

You can reset the 802.1x configuration parameters to the default values with a single command, which
also globally disables 802.1x.
To reset the 802.1x configuration parameters to the default values, perform this task in privileged mode:
Task
Step 1
Reset the 802.1x configuration parameters to the
default values and globally disable 802.1x.
Step 2 Verify the 802.1x configuration.
This example shows how to reset the 802.1x configuration parameters to the default values and verify
the configuration:
Console> (enable) clear dot1x config
This command will disable dot1x on all ports and take dot1x parameter values back to
factory defaults.
Do you want to continue (y/n) [n]?
Console> (enable) show dot1x
PAE Capability
Protocol Version
system-auth-control
max-req
quiet-period
re-authperiod
server-timeout
supp-timeout
tx-period

Setting the Trace Severity

You can alter the trace severity for 802.1x authentication with this command. The number setting affects
the number of trace messages displayed. Low numbers result in fewer messages; high numbers result in
more messages.
To set the trace severity for 802.1x, perform this task in privileged mode:
Task
Set the trace severity for 802.1x authentication. set trace dot1x trace-level
This example shows how to set the trace severity for 802.1x authentication to 5:
Console> (enable) set trace dot1x 5
DOT1X tracing set to 5
Warning!! Turning on trace may affect the operation of the system.
Use with caution.
78-12647-02
Authenticator Only
1
enabled
2
60 seconds
3600 seconds
30 seconds
30 seconds
30 seconds
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Command
clear dot1x config
show dot1x
Command
Configuring Authentication
27-45