Displaying Etherchannel Pagp Statistics; Etherchannel Configuration Examples; Four-Port Fast Etherchannel Configuration Example - Cisco WS-C4003 - Catalyst 4000 Chassis Switch Software Configuration Manual

Chapter 6 Configuring Fast EtherChannel and Gigabit EtherChannel

Displaying EtherChannel PAgP Statistics

To display EtherChannel PAgP statistics, perform one of these tasks in privileged mode:
Task
Display EtherChannel PAgP statistics by port.
Display EtherChannel PAgP statistics by
EtherChannel administrative group.
Display EtherChannel PAgP statistics by
EtherChannel ID.
This example shows how to display EtherChannel PAgP statistics information by EtherChannel
administrative group:
Console> show channel group 58 statistics
Port
----- ------- ----------- --------- --------- --------- --------- ---------
3/5
3/6
Console> (enable)

EtherChannel Configuration Examples

These sections contain Fast and Gigabit EtherChannel configuration examples:
•
•
Note For examples of configuring VLAN trunks on EtherChannel port bundles, see the
Trunk Configurations" section on page

Four-Port Fast EtherChannel Configuration Example

This example configuration shows how to configure a four-port Fast EtherChannel link between two
switches.
78-12647-02
Admin PAgP Pkts PAgP Pkts PAgP Pkts PAgP Pkts PAgP Pkts PAgP Pkts
Group Transmitted Received
58 194
58 204
Four-Port Fast EtherChannel Configuration Example, page 6-11
Two-Port Gigabit EtherChannel Configuration Example, page 6-13
Figure 6-1 shows two switches connected through four 100BASE-TX Fast Ethernet ports.
Software Configuration Guide—Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4
Command
show port channel [mod_num[/port_num]]
statistics
show channel group [admin_group] statistics
show channel [admin_group] statistics
InFlush RetnFlush OutFlush
81 0 0
85 0 0
11-7.
EtherChannel Configuration Examples
InError
0 0
0 0
"Example VLAN
6-11