Novell LINUX ENTERPRISE SERVER 11 - ADMINISTRATION Administration Manual page 264

neighbour
This object represents a ARP or NDISC cache entry.
route
This object represents the routing table entry.
rule
This object represents a rule in the routing policy database.
maddress
This object represents a multicast address.
mroute
This object represents a multicast routing cache entry.
tunnel
This object represents a tunnel over IP.
If no command is given, the default command is used (usually list).
Change the state of a device with the command ip link
set device_name command. For example, to deactivate device eth0, enter ip
link set eth0 down. To activate it again, use ip link set eth0 up.
After activating a device, you can configure it. To set the IP address, use ip addr
add ip_address + dev device_name. For example, to set the address of the
interface eth0 to 192.168.12.154/30 with standard broadcast (option brd), enter ip
addr add 192.168.12.154/30 brd + dev eth0.
To have a working connection, you must also configure the default gateway. To set a
gateway for your system, enter ip route add gateway_ip_address. To
translate one IP address to another, use nat: ip route add
nat ip_address via other_ip_address.
To display all devices, use ip link ls. To display the running interfaces only, use
ip link ls up. To print interface statistics for a device, enter ip -s link
ls device_name. To view addresses of your devices, enter ip addr. In the output
of the ip addr, also find information about MAC addresses of your devices. To show
all routes, use ip route show.
250 Administration Guide