Novell LINUX ENTERPRISE SERVER 11 - ADMINISTRATION Administration Manual page 110

GRUB and XFS
XFS leaves no room for stage1 in the partition boot block. Therefore, do not
specify an XFS partition as the location of the boot loader. This problem can be
solved by creating a separate boot partition that is not formatted with XFS.
GRUB Reports GRUB Geom Error
GRUB checks the geometry of connected hard disks when the system is booted.
Sometimes, the BIOS returns inconsistent information and GRUB reports a GRUB
Geom Error. In this case, update the BIOS.
GRUB also returns this error message if Linux was installed on an additional hard
disk that is not registered in the BIOS. stage1 of the boot loader is found and
loaded correctly, but stage2 is not found. This problem can be remedied by regis-
tering the new hard disk in the BIOS.
System Containing Several Hard Disks Does Not Boot
During the installation, YaST may have incorrectly determined the boot sequence
of the hard disks. For example, GRUB may regard the IDE disk as hd0 and the
SCSI disk as hd1, although the boot sequence in the BIOS is reversed (SCSI before
IDE).
In this case, correct the hard disks during the boot process with the help of the
GRUB command line. After the system has booted, edit device.map to apply
the new mapping permanently. Then check the GRUB device names in the files
/boot/grub/menu.lst and /boot/grub/device.map and reinstall the
boot loader with the following command:
grub --batch < /etc/grub.conf
Booting Windows from the Second Hard Disk
Some operating systems, such as Windows, can only boot from the first hard disk.
If such an operating system is installed on a hard disk other than the first hard disk,
you can effect a logical change for the respective menu entry.
...
title windows
...
In this example, Windows is started from the second hard disk. For this purpose,
the logical order of the hard disks is changed with map. This change does not affect
96 Administration Guide
map (hd0) (hd1)
map (hd1) (hd0)
chainloader(hd1,0)+1