AMX Modero NXA-WAP200G Instruction Manual page 9

Specifications (Cont.)
Front Components:
LEDs
Rear Components:
Power connector
Reset button
LAN port
LAN/PC switch
Antenna connector
Certifications:
Security Features:
Operating/Storage
Environments:
Included Accessories:
NXA-WAP200G Wireless Access Point
• Three blue activity and status LED indicators
• Refer to the following LEDs section on page 4 for more information.
Two power options available:
• AC Adapter connects to an external power adapter.
• Power Over Ethernet (PoE) powers the device through the CAT5 cable.
Both Power and Data can be transmitted simultaneous through the CAT5
cable when using the appropriate equipment.
• Pressing this button for 10 seconds, restores the default settings.
Note: Resetting the WAP will erase all of your settings (WEP Encryption,
Wireless and LAN settings, Passwords, etc.) and restore them to their factory
default values. Do not reset the WAP if you want to retain these settings.
• One 10/100M (RJ-45) connector.
• This 10/100 Ethernet Port (RJ-45 Connector) is used to connect the WAP to
your LAN and/or to connect your Internet device to the LAN when the
NXA-WAP200G is used as a Bridge.
The NXA-WAP200G can operate as a Wireless Access Point or as a Bridge.
• Single AP - BRIDGE toggle switch
• When configured as a Wireless Access Point it allows multiple computers to
connect to the LAN wirelessly.
• When configured as a Bridge it allows devices with a 10/100 port, but without
wireless capability, to be connected to the wireless LAN, such devices
include desktop computers, printers, X-Boxes, PlayStation2s, PVRs,
Stereos, etc.
• When the NXA-WAP200G is used a Wireless Access Point the toggle switch
should be positioned to AP.
• When it is used as a Bridge it should be positioned to BRIDGE.
• Single 3 dBi external antenna with reversed SMA connector.
• This is the connection point for any of the four optional external antennas.
Refer to the WAP200G Accessories section on page 5 for more information.
• FCC, IC, CE, TELEC
• MAC Address filtering
• Disabling of Wireless Beacon
• Hiding of SSID information
• 64 and 128-bit WEP Encryption
• Operating Temperature: 0°C (32°F) to 50°C (122°F)
• Storage Temperature: -25°C (-13°F) to 70°C (158°F)
• Relative Humidity: 10% to 90% non-condensing
• One power adapter
• Four international plug adapters (US/Japan, Europe, UK, and Australia)
• Surface mounting kit (including two screws)
Introduction
3