AMX Modero NXA-WAP200G Instruction Manual page 60

AP/Repeater Configuration Utility Pages
To enable this feature, select the Enable access control check box and enter the MAC Addresses of
all authorized devices for network access. Enter the information into the different fields on this
page as desired and then press Save when done. The fields in the Access Control page (FIG. 42) are
described in the table below.
Access Control Page Information
Enable Access Control:
MAC Address # (1-8):
Save/Cancel:
FIG. 42 Access Control for Enhanced Security page
54
• Enables/disables the ability for only those addresses entered into the
remaining MAC Address fields to have access to the network through the
WAP200G.
• Unique MAC Addresses for those communicating devices seeking access to
the network through the WAP200G (such as Modero panels).
• Note: You can cut and paste the MAC Addresses from the Connected
Devices page into the MAC Address boxes. These changes are effective
immediately.
• Press the Save button to incorporate the new information to the WAP200G.
• Press the Cancel button to terminate the process and return the fields to
their default values.
NXA-WAP200G Wireless Access Point