Led Status Indication - TP-Link SafeStream TL-ER6020 User Manual

LEDs

LED Status
On
PWR
Off
Flashing
SYS
On/Off
On
Link/Act
Off
Flashing
On (Green) The linked device is running at 1000Mbps
On (Yellow) The linked device is running at 100Mbps
Speed
Off
On
DMZ
Off
Interface Description

Interface Port
WAN 1~2
LAN 1~3
DMZ 3
Console N/A
Reset button

Use the button to restore the Router to the factory defaults. With the Router powered on, use a pin to
press and hold the Reset button (about 4~5 seconds). After the SYS LED goes out, release the Reset
button. If the SYS LED is flashing with a high frequency about two or three seconds, it means the Router
is restored successfully.
Indication
The Router is powered on
The Router is powered off or power supply is abnormal
The Router works properly
The Router works improperly
There is a device linked to the corresponding port
There is no device linked to the corresponding port
The corresponding port is transmitting or receiving data
There is no device linked to the corresponding port or the
linked device is running at 10Mbps
The port is working in DMZ mode
The port is working in LAN mode
Description
The WAN port is for connecting the Router to a DSL/Cable
modem or Ethernet by the RJ45 cable
The LAN port is for connecting the Router to the local PCs or
switches by the RJ45 cable
The DMZ port is for connecting the Router to the servers
The Console port is for connecting with the serial port of a
computer or terminal to monitor and configure the Router
-7-