TP-Link SafeStream TL-ER6020 User Manual page 33

Auth Domain:
Auth Mode:
MTU:
Upstream/Downstream
Bandwidth:
 BigPond Status
Status:
IP Address:
Subnet Mask:
Enter the domain name of authentication server. It's only required
when the address of Auth Server is a server name.
You can select the proper Active mode according to your need.
Manual: Select this option to manually activate or terminate the

Internet connection by the <Connect> or <Disconnect> button.
It's optimum for the dial-up connection charged on time.
Always-on: Select this option to keep the connection always on.

The connection can be re-established automatically when it is
down.
MTU (Maximum Transmission Unit) is the maximum data unit
transmitted by the physical network. It can be set in the range of
576-1500. The default MTU is 1500.
Specify the Upstream/Downstream Bandwidth for the port. To make
"Load Balance" and "Bandwidth Control" take effect, please set
these parameters correctly.
Displays the status of BigPond connection.
"Disabled" indicates that the BigPond connection type is not

applied.
"Connecting" indicates that the Router is obtaining the IP

parameters from your ISP.
"Connected" indicates that the Router has successfully

obtained the IP parameters from your ISP.
"Disconnected" indicates that the connection has been

manually terminated or the request of the Router has no
response from your ISP. Please ensure that your settings are
correct and your network is connected well. Consult your ISP if
this problem remains.
Displays the IP address assigned by your ISP.
Displays the Subnet Mask assigned by your ISP.
-28-