TP-Link SafeStream TL-ER6020 User Manual page 102

Remote Subnet:
Status
 List of Configurations
In this table, you can view your configurations of the tunnels and edit them by the action buttons.
The No.1 entry in Figure 3-63 indicates: this tunnel is encapsulated by using L2TP. Its user name is
test, the password can be configured, and the Router is configured in Client mode. The remote
server is 172.30.70.161 and the remote subnet is 192.168.2.0/24. This entry is enabled.
3.5.3.2 IP Address Pool
On this page, you can configure the IP Address Pool.
Choose the menu VPN→L2TP/PPTP→IP Address Pool to load the following page.
The following items are displayed on this screen:
 IP Address Pool
Pool Name:
IP Address Range:
 List of IP Pool
Enter the IP address range of your remote network. (It's always the IP
address range of LAN on the remote peer of VPN tunnel.) It's the
combination of IP address and subnet mask.
Activate or inactivate the entry.
Figure 3-64 IP Address Pool
Specify a unique name to the IP Address Pool for identification and
management purposes.
Specify the start and the end IP address for IP Pool. The start IP address
should not exceed the end address and the IP ranges must not overlap.
-97-